Standard Code for Inspection of Body Reflection

Answer 1

The inspection of the reflective marking on the body of the car has the following standard specifications:
1. ** Material requirements **: The reflective marking material for the body of a cargo-carrying vehicle should meet the relevant technical requirements. Other types of vehicles can follow suit. The reflective film type body reflective logo shall be a strip-shaped reflective film material with alternating red and white units, and the surface shall be intact and without damage. The length of each red and white unit shall be between 150mm and 450mm, and the width may be 50mm, 75mm or 100mm. The white unit shall be marked with a "3C" mark that meets the requirements.
2. ** Reflective coefficient **: The reflection coefficient of the red label must not be lower than 50, and the reflection coefficient of the white label must be higher than 250 to be qualified.
3. ** Color and distribution regulations **
- The color of the car reflective sticker was stipulated to be red and white. The body reflective marking at the rear of the vehicle shall start with a white unit and end with a white unit. The side may start with a red unit, but the last unit near the rear of the vehicle must be a white unit.
- In China, the reflective labels of different colors were used in different areas. The reflective labels on the car body were red and white. The European standard stipulated that the reflective logo on the car body could be one of yellow, white or red. The yellow one could be attached to the side and back of the car body, the white one could only be attached to the front of the car body, and the red one could only be attached to the back of the car body.
- China's standards stipulated that reflective labels were divided into level one and level two. Level one included red and white and pure white.
4. ** Paste Requirements **
- Trucks (except for multi-purpose trucks and coach vehicles modified from multi-purpose trucks), special work vehicles modified from truck chassises, other vehicles with a maximum design speed of less than or equal to 40km/h, and all trailer (except caravan) shall be equipped with rear body reflective marks, vehicle tail marking plate, and side body reflective marks in accordance with 8.4.1, 8.4.2 and other relevant regulations of GB7258 -2017.
- The reflective sticker of a motor vehicle's body was required to be at least 380mm from the ground. After the reflective logo is attached to the body, it should not affect the performance of the vehicle's lighting and signal devices, nor should it drill holes or groove on the logo.
Read more exciting novels for free