The simplest way to solve the Rubik's cubeThere were many ways to solve the Rubik's cube.
1. The simplest way to make a cross was easier to understand but slower. First, find the white block, move the white block to the side of the yellow center, and then turn the layer where the yellow center block is located until the other block in the block is the same as the center block below. Then turn F2 to pull them to the bottom white center.
2. Second-order restoration steps: first complete the white surface, use the formula to go up, left, down, right; then complete the yellow surface, use the formula to go up, left, down, right, multiply by 2; finally complete the upper four edges, use the formula to go up, right, upper, lower, turn 2, lower, left, left.
3. The Seven-Step Restoration Method was the most basic restoration method, suitable for beginners to learn. The specific steps and formulas could be found in the relevant tutorial.
4. [Order reduction method: For a fourth-order Rubik's cube, you can use the order reduction method to convert it into a third-order Rubik's cube, and then restore it according to the method of restoring a third-order Rubik's cube.]
It should be noted that everyone's learning and understanding ability is different, so the simplest method may vary from person to person. It is recommended to choose a method that suits you according to your personal situation and practice it repeatedly to improve your speed and proficiency.
Rubik's cube how to solve the restoration tutorialThe following are a few Rubik's cube restoration courses:
** 1. Three-Order Rubik's Cube Four-Step Recovery Method **
1. [First step: White cross on the bottom]
- He turned all the white blocks to the bottom and aligned the color of these blocks with the center block. If the color of an edge block is opposite to that of the center block, you can use the edge changing formula (such as "top, outside, bottom, inside, top") to adjust it so that the color of each edge block is consistent with the center block.
2. [Second step: Restore the corner and the prism]
- Find the same set of corners and edges on each side of the Rubik's cube. For example, for a combination of a white corner block (white state) and an edge block (such as an orange-green corner block and an edge block), you can do the white f formula (hiding the edge and moving the corner), and then change the corner block to the edge block to form the same color state. When it is on the right side, you can use your right hand to hook up and back down the formula.
3. [Step 3: Readjust the orientation of the top floor]
- After the first two levels were restored, the top might be in the state of a small fish. If the top surface is a specific figure (such as the yellow center and the two diagonally opposite yellow corner blocks forming an oblique line), the corresponding formula can be used according to different situations. For example, if there are two sides of the same color and the side faces the back, or if there is only one color corresponding to a certain position on a single side, use the formula "Up, Left, Down, Left, Down, Up, Reverse, Left, Down, Up, Reverse" to adjust the color of the top surface to be the same as the color of the center (all become yellow).
4. ** Step 4: adjust the color of the side **
- When there is a situation where the position of the corner block is incorrect (such as the position of the three corner blocks is incorrect and the position of the edge block is correct), it can be adjusted according to the specific situation.
** Second and Third Order Rubik's Cube Five-Step Recovery Method **
1. [Step 1: White Cross]
- The white center was facing up, and there were four white edges. If there are white edges on the side and white blocks on the top, move aside first; If there are white blocks on the bottom and white blocks on the top, move aside and turn the white blocks on the bottom.
2. ** Second step: Restore the bottom layer corner block and middle layer prism block **
- Cross face down, find the corner block with white color on the third layer (top layer) and determine the matching color of the corner block. If there were no matching blocks on the top floor, they had to find and adjust them to the appropriate position on the other floors. Different formulas were used according to different situations, such as "Right Turn Down Right Up","Right Up Left Down Right Up Right Down","Left Up Left Down Right Up Right Down","Right Up Right Down Right Up Right Down","Right Up Right Down Right Up Left Down", etc., to restore the bottom corner block and the middle layer prism block at the same time.
3. [Step 3: Readjust the orientation of the top floor]
- Use the formula to adjust the color of the top side to be the same as the color of the center (for example, make the other yellow sides face up).
4. ** Step 4: adjust the color of the side (the specific formula is not given in the information, but follow the principle of adjusting the position of the corner block)**
- It solved the problem of the incorrect position of the corner block on the side.
5. ** Step 5: Complete the Rubik's Cube Restoration (This step was not specified in the information, presumably to check if the entire Rubik's Cube was restored)**
** 3rd, 3rd Order Rubik's Cube Simple Three-Formula Recovery Method (Part of the Steps)**
1. ** White cross on the bottom **
- There were many ways to make a white cross on the bottom. You could make a white flower according to your own method (a prerequisite for forming a white cross on the bottom).
2. ** Restore the corner block at the bottom layer **
- He could use a formula to restore the corner block at the bottom layer, or he could combine the left and right hand formulas to increase the speed.
3. ** Restore the middle layer's prism block **
- Using the "hook up and back down" formula, it was easy to complete the restoration of the middle layer prism block.
4. ** Restore the top yellow cross **
- The right-hand formula's "hook up, back down" plus the step of pressing down and picking up, or the "hook up, back down" formula (when there is only one yellow center, use two steps to make a yellow cross).
5. ** Restore the top layer's yellow surface **
- This step could be achieved by using the right hand to "hook up and back down" twice.
6. ** Restore the top corner and edge blocks **
- You can use the two new formulas that look longer but are easy to remember.
** The method to restore the second, third and fourth level of the fourth and fifth order Rubik's cube **
1. First, check the color of the big pillar. If it was blue and on the left-hand side, he would use his left hand to do the "hook up and back down" first.
2. Then, he turned the Rubik's cube around, and White did a 'hook up and back down' on himself.
3. Find another group that doesn't have a red color. If the top is red and on the left-hand side after alignment, do "tick up and back down".
4. Then, he turned it around and used White to do a 'hook up and back down' on himself.
5. For the rest of the groups, if they were on the left hand side, they would do "hook up and back down", then turn to the blue and do "hook up and back down" for themselves. If they were on the right side, they would first use their right hand to hook up and back left, then turn to the left hand and hook up and back left. In this way, the third, fourth, second, third, and fourth layers would be restored.
There was also a simple and crude method (irregular reduction method):
1. He unscrewed the corner blocks and other modules of the Rubik's cube.
2. First pick out the white part and put the middle part together. For example, put the relevant module on the left and then swipe it up to make it fit.
3. After assembling the cross at the bottom, he began to assemble the white corner pieces. It was easier to assemble them diagonally.
4. He pieced the first layer, the second layer, the top cross, and the corner block in order to complete the restoration of the Rubik's cube.
The Rubik's Cube"Rubik's Cube World" was a game novel written by a sheep-horned cat. It was published on the 2D novel platform Impossible World and had been completed. The main characters were Su Ling and Xia Xinxuan. Su Ling was 22 to 25 years old. She graduated from university, had facial paralysis, and had social barriers. She was an all-rounder player who hated puzzle and horror games. She entered Rubik's Cube World with her real name and appearance, and her personal signature was "There is a vicious dog inside, strangers are not allowed to approach."
There was also 'The World's Rubik's Cube (Transmigration and Rebirth)' written by Charcoal Grilled Bamboo Rice. The first true holographic game in the novel, World Rubik's Cube, publicly recruited 200 test players from all over the world, including a beggar named Que Zhou. Although Magpie Boat was cursed and ridiculed by many players, his performance in the game was impressive. He entered the game with a mission. His goal was to become one of the best two out of the two hundred examiners. This way, he could appear at the live broadcast of the World's Rubik's Cube conference and seek justice for his idol.
<a href="/?from=ask_words" style="color:red" target="_blank">Read more exciting novels for free</a>
Rubik's Cube? What the hell is that? Don't you mean the Tesseract? How is it possible that in a Chinese-English translation, "Tesseract" becomes "Rubik's Cube"?