How do you make cute pet dolls in Pikachu?

Answer 1

If you want to make a Pikachu cute pet doll (inflatable doll), the production method is as follows: This inflatable doll was launched by the Japanese brand Jam Store. Its body shape is similar to a real pet. It has long ears, a round body, and a four-legged posture. The length, width, and height are 470×370× 500mm, and it can withstand a weight of 100kg. However, he did not find out the specific production process and could not provide more information about the production of this inflatable doll.

If you make Pikachu out of balloons The steps were as follows: First, fill the yellow 260 with air, leave eight fingers at the end, tie a knot, twist a two-fingered single bubble, pinch the joint tightly, and twist it into a bear ear knot; Make a five-fingered single bubble, a two-fingered single bubble, twist the two-fingered single bubble into a bear tail knot, and then twist the five-fingered single bubble on the other side of the ear knot, and repeat this process; The four single bubbles of the five fingers formed a body with a four-bubble knot. The body with a four-bubble knot should be tidied up to find a nice side, and then the small feet of the four-bubble knot doll should be made.(Two and a half to three fingers, the ratio can be adjusted), the excess ball skin was cut off, and the remaining ball skin was wrapped in the balloon to cover it. Then, he chose a piece of waste ball skin to inflate, filling about seven fingers, making a single bubble with seven fingers. After cleaning the light bulb, he tied a knot, and the other piece of waste ball skin also filled a single bubble with seven fingers. Then, he tied the two single bubbles together to form Pikachu's ears. Then, he twisted the ear on the ear knot, tightened one side, covered the ball skin inside its body, stuffed it up to cover the other side, and wrapped it around the ear knot. The ball skin on the ear knot was also covered, and the doll was completed. Finally, he could also use the ear to draw. He used a black pen to draw the small ears, eyes, mouth, and add a little blush.

If the clay was used to make a Pikachu doll, the clay would be roughly divided into two parts, the head and the body. The details had to be paid attention to, especially the production of the five senses, but the specific steps were not inquired.

If you want to make a Pikachu finger doll with origami, first prepare a piece of yellow square paper, fold the two corners into a triangle shape; fold the left and right corners in half; fold them in half, and then restore them to the original shape. There is a crease in the middle, then fold the right side down along the crease, and fold the left side down along the crease; fold the bottom two corners upward in an inclined manner.(These two corners will become Pikachu's ears, but they haven't been fixed yet); Fold the bottom corner up into a triangle shape.(Fold it up with a gap on both sides); open the triangle folded in the previous step and stuff it into the bottom pocket; open the triangle folded up (Because the other triangle has been stuffed into the pocket); Fold the two corners (from the top corner to the bottom corner to form a straight line) to fold the Pikachu's two ears; Fold the excess part of the bottom up; Fold the top corner down, turn it to the front, and then draw black on the Pikachu's ears with a pen. Then draw the mouth and put the eyes on (if there is none, draw it on).
Read more exciting novels for free