How to solve the problem of no response when the computer reinstalled the system and entered the page?

2026-08-08 12:10

If there is no response when the computer is reinstalled, you can refer to the following solutions: * * 1. In terms of software ** 1. * * Turn off the anti-virus software ** - When installing the system, the key boot options would be changed, and the anti-virus software might block it and cause it to not be reinstalled. Close all anti-virus software before reinstalling the system. 2. * * Check the image file ** - If there is a problem with the image file, an error will appear during the copying process, causing the system to fail to install. You need to download the image file again. 3. * * Check the installation program ** - If the system software was reinstalled with one click and the computer only had one C drive or the system image of the software was installed on the C drive, the reinstallation of the system would format the C drive. If the system software was installed on the C drive, it would not work normally. You need to move it to a disk other than the C drive, or use the system-provided partition tool to repartition the C drive. - If you are in the process of installing the system (for example, after downloading the system from the MSIM System Library), follow the correct steps. For example, run the setup file as an administrator, click Next, wait for the update to be completed, and then click Next to ensure that there are no operational errors. 4. * * Check system compatibility ** - When installing the system, check if your computer can support the system. For example, if the computer was pre-installed with the Win10 system in the Ufei + Gpt partition boot mode and wanted to change to Win7, the system software might be prompted that the machine did not support it when it was reinstalled with one click. In this case, it needed to be changed to the traditional Biao + Membrane partition mode. * * 2. In terms of hardware ** 1. * * Check the optical drive and CD (if installing from CD)** - Setting up the CD drive to start, check the CD and CD drive for problems. Sometimes the computer could not install the system because the CD was damaged or read incorrectly. At this time, you need to use another CD to solve the problem. 2. * * Check the hard disk ** - Hard disk connection problems or partition errors may cause the operating system to fail to boot. You can check whether the hard drive power supply is bad. If it is a Dell Latitude 5280 win10 computer, the inability to boot after reinstalling the system may be caused by a damaged hard drive or a bad hard drive power supply. In this case, you can switch the hard drive off and replace it. - If the system was not reformat, the hard disk would not have much space left or there would be too many fragments. When using the computer, make sure to reserve a certain amount of disk space for the computer and defragment the computer regularly. - If the main partition was damaged, he could consider changing the hardware, and if the C drive was insufficient, he could expand the space. 3. * * Check other hardware ** - There may be a hardware conflict, such as a conflict in the settings of the sound card or display card, causing the system to be stuck. The solution is to restore the state before the hardware change and check if the system can start normally. - There was a problem with the hard disk controller on the motherboards, causing unstable data transmission. The error rate was too high, and it would also cause the phenomenon of not being able to boot. You can refer to the information about the CPU jumpers in the Motherboard Manual and clear the CPU jumpers. Note that when clearing the CPU settings, you must unplug the power cord of the host or set the power switch of the host to off or 0. - It could also be a problem with the monitor. The monitor was turned off and the computer couldn't see the screen. Or there was a problem with the power supply of the monitor. Check if there was a problem with the plug and socket. Read more exciting novels for free