Peugeot 301 Mirror BaseThe original rearview mirror base support column cover (center column small cover, rearview mirror column cover) for the Peugeot 301 was priced at 20 yuan, and there were discounts (5 yuan for 100 yuan, 25 yuan for 500 yuan, 15 yuan for 300 yuan, 2 yuan for 65 yuan, 20 yuan for 400 yuan, 10 yuan for 200 yuan, and 30 yuan for 600 yuan). If there is no rain sensor on the base of the rearview mirror, you can rotate it 90 degrees to the left and then remove it. When installing it, you can rotate it 90 degrees to the right (because the iron clip on the base is stuck to the upper base). If there is a rain sensor, you need to first remove the plastic cover, then use your fingers to push down along the groove, while shaking left and right, and then remove the base.
<a href="/?from=ask_words" style="color:red" target="_blank">Read more exciting novels for free</a>
Peugeot 307, slow acceleration and reactionThe Peugeot 307's slow acceleration could be caused by a variety of reasons.
As for the fuel system, if there was carbon deposit or mechanical failure in the fuel injection, it might cause the acceleration response to be slow. For example, during acceleration, if the speed dropped sharply and was accompanied by shaking, the fuel injection valve needed to be checked. If it was blocked, it could be cleaned, and if it was damaged, it needed to be replaced. In addition, if there was a problem with the oil pump or the fuel filter was blocked, it would affect the oil pressure and make the acceleration difficult, so it was necessary to change the fuel filter regularly.
If there was a problem with the half-shaft, the car would jump regularly when accelerating. After releasing the accelerator, the shaking would reduce or disappear. However, this problem was difficult to determine by itself. It was best to have it repaired by a professional.
In addition, you can also use the diagnosis tool to read the engine fault code. If you find that there is a problem with the fuel injection system, refer to the circuit diagram of the relevant model series to check the circuit connection, fuel pressure, and injection mode of the fuel injection. If necessary, clean or replace the fuel injection device, replace the fuel filter, check and replace the high-pressure fuel pump with reduced performance, and finally clear the fault code and perform a road test.
<a href="/?from=ask_words" style="color:red" target="_blank">Read more exciting novels for free</a>
Peugeot 307, come on, slow reactionThe slow reaction of the Peugeot 307 could be caused by many reasons. If there were too many carbon deposits, such as carbon deposits in the throttle, air intake, and three-way catalyst, it would cause the engine to lack power and slow down the response to refuelling. In this case, the carbon deposits needed to be cleaned and the throttle needed to be reset with a computer. Problems with the ignition system could also be caused, such as damage to the ignition coil, excessive spark plug gap, serious carbon deposits on the spark plug, insufficient ignition voltage, reaching the limit of life, etc., which could cause insufficient power and slow acceleration. The spark plug could be cleaned or replaced according to the situation. The use of low-quality gasoline would also cause this problem. Low-quality gasoline had many impurities, was mixed with water, had low fuel heat value, and low thermal efficiency, which would cause insufficient combustion. Not only would the accelerator react slowly, but over time, it would also form carbon deposits that would damage the engine. Therefore, it should be avoided to refuel at irregular gas stations. In addition, if the fuel supply pressure of the gasoline pump is insufficient, it is recommended to clean the oil circuit, replace the gasoline filter, and then check whether the fuel supply pressure of the gasoline pump is within the normal range.
<a href="/?from=ask_words" style="color:red" target="_blank">Read more exciting novels for free</a>
Super tout recommencer à nous et choisir sa vie ,vraiment super 👍🏻